F 150 4WD V8-4.6L VIN 8 (2010)
10. NOTICE: For vehicles equipped with a 4.6L or 5.4L engine, do not touch the electrical connector pins or the exposed solenoid tabs on the
transmission bulkhead electrical connector. Electrostatic discharge may occur and may cause damage to the Transmission Control
Module (TCM).
With the release tab down and unlocked, push the outer shell of the transmission bulkhead electrical connector into the transmission. Make sure
that the transmission bulkhead electrical connector is fully seated into the mechatronic assembly.
11. Press up on the tab and lock the outer shell of the transmission bulkhead electrical connector in place. Make sure that the locking tab is securely
locked.
12. NOTE: The transmission fluid filter may be reused if no excessive contamination is indicated.
If required, install a new transmission fluid filter.
13. NOTE: The transmission fluid pan gasket can be reused if not damaged.
Install a new transmission fluid pan gasket, if required.
14. Install the transmission fluid pan and tighten the transmission fluid pan bolts in a crisscross pattern.
-
Tighten to 12 Nm (106 lb-in).
15. Connect the transmission vehicle harness connector by pushing it in and twisting the outer shell to lock it in place.