F 150 4WD V8-5.4L Flex Fuel (2008)
7. NOTE: LH side shown, RH side similar.
Push the outside edge of the moulding in toward the center of the vehicle and slide the moulding off the inside edge of the Y-clip.
8. Release the moulding from the remaining 3 Y-clips and remove the moulding.
9. NOTE: LH side shown, RH side similar.
Remove the Y-clips.
-
Starting with the bottom Y-clip, work upward toward the roof. Use light pressure to separate the A-pillar track near the Y-clip, then remove the
Y-clip.
10. Before cutting the urethane adhesive, remove dirt and other foreign material from the windshield pinchweld area.
-
Use a clean shop towel or oil-free compressed air.
11. NOTE: Refer to the manufacturer's instructions before using the special tool.
Lubricate the urethane adhesive with water to aid the Interior Auto Glass Cut-Out Knife Kit when cutting the urethane adhesive.
12. WARNING:
-
Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
-
Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this instruction may
result in serious personal injury.
CAUTION: To avoid rust formation, use extreme care not to scratch the paint or primer or otherwise damage the pinchweld during
glass removal.
NOTE:
-
Insert the blade into the special tool so that the flat side is against the glass. This will leave the entire urethane adhesive bead on the pinchweld