F 150 4WD Pickup V8-281 4.6L VIN W EFI (1997)
16. Insert a dulled screwdriver blade to relieve built up air pressure in the front wheel driveshaft joint boot.
NOTE: The air should be released only after adjusting the CV joint to boot spacing.
17. Use the CV Boot Clamp Installer to install the two inboard boot clamps.
18. Position the clamp protectors over the inboard boot clamps.
19. Install the front wheel driveshaft and joint, please refer to Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/
Axle Shaft/Service and Repair/ See: