F 250 2WD Pickup V8-351 5.8L VIN H 4-bbl HP (1985)
3.
Snap a new spacer into the hole from outside the door (Figure 2).
DOOR OR LIFTGATE INSTALLATION/REMOVAL
When replacing the door of liftgate assembly, the new door or liftgate may have the larger lock cylinder hole. Measure the hole diameter (Figure 2). If
dimension "X" is more than 24 mm, then a spacer is required. If it is less than 24 mm, then a spacer cannot be used.
NOTE:
EVEN IF THE ORIGINAL DOOR HAS A SPACER, ONE IS NOT NEEDED IF THE "X" DIMENSION IS LESS THAN 24 mm IN THE NEW
DOOR.
