ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3154 > < Initial Inspection and Diagnostic Overview|Page 3152
Page 56
background image

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with a TBC module, GO to T13.

If the vehicle is not equipped with a TBC module, GO to T14.

No

CONNECT all modules. CONNECT the negative battery cable. GO to T32.

-------------------------------------------------
T13 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE TBC MODULE DISCONNECTED

-

Disconnect: TBC Module C2142.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to T14.

No

CONNECT all modules. CONNECT the negative battery cable. GO to T33.

-------------------------------------------------
T14 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE RCM DISCONNECTED

-

Disconnect: RCM C310b.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with an APIM, GO to T15.

If the vehicle is not equipped with an APIM, GO to T16.

No

Initial Inspection and Diagnostic Overview|Page 3154 > < Initial Inspection and Diagnostic Overview|Page 3152