F 250 2WD Super Duty V10-6.8L (2009)
CONNECT all modules. CONNECT the negative battery cable. GO to T34.
-------------------------------------------------
T15 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE APIM DISCONNECTED
-
Disconnect: APIM C3342.
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.
-
Is the resistance less than 5 ohms?
Yes
GO to T16.
No
CONNECT all modules. CONNECT the negative battery cable. GO to T35.
-------------------------------------------------
T16 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE IC DISCONNECTED
-
Disconnect: IC C220.
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.
-
Is the resistance less than 5 ohms?
Yes
If the vehicle is equipped with a diesel engine, GO to T17.
If the vehicle is not equipped with a diesel engine, REPAIR the circuits. CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the
scan tool.
No
CONNECT all modules. CONNECT the negative battery cable. GO to T36.
-------------------------------------------------
T17 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE EVRT ACTUATOR
DISCONNECTED
-
Disconnect: EVRT Actuator C1390.
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.