F 350 2WD Pickup V8-460 7.5L VIN G EFI (1997)
CAUTION: Do not fully compress the return springs.
7. Alternately install the (A) steel and the (B) friction clutch plates, beginning with a steel plate and ending with the (C) direct clutch pressure plate.
CAUTION: Mixing or using friction plates without the grooves will cause shift concerns and can cause damage.
NOTE:
-
The direct clutch friction plates have lube grooves in the friction material.
-
Depending on model, install a 3-, 4-, or 5- plate clutch pack.
8. Install the selective direct clutch pressure plate retaining ring.
9. Using a feeler gauge, check the stack-up clearance in three places, 120 degrees apart.
-
If the clearance is not to specification, install the correct selective direct clutch pressure plate retaining ring and recheck the clearance.
10. Install the No. 7 intermediate one-way clutch large thrust washer, aligning the (A) tabs with the (B) notches.