F 350 4WD Pickup V8-7.3L DSL (1988)
2. Position the master cylinder assembly over the booster push rod and onto the two studs on the booster assembly. Install the attaching nuts and
tighten to 24-34 Nm (18-25 ft lbs).
3. Connect the hydraulic brake system lines to the master cylinder.
4. Connect fluid level indicator switch.
5. Bleed the master cylinder. Fill the reservoir of the master cylinder with heavy duty DOT 3 brake fluid to the fluid fill line. Install gasket and bleed
the system. Refer to Brake Bleeding.
For additional information see Fundamentals and Basics.
Rebuild
Master Cylinder
DISASSEMBLY
1. Clean outside of the master cylinder. Remove the plastic cap and gasket. Drain and discard any brake fluid that remains in the cylinder.
2. Remove the proportioning valve from the master cylinder.
3. Remove stop-bolt from the bottom of the master cylinder assembly.