F 350 4WD Pickup V8-7.3L DSL Turbo VIN F (1994)
13. Pull axle shaft assembly out of steering knuckle.
Installation
1. NOTE: Replacement spindle bearings are shipped with a corrosion preventive gel. This is not a lubricant. Bearing must be cleaned and repacked
with the specified greased. If removed, pack a new bearing with High Temperature 4x4 Front Axle and Wheel Bearing Grease E8TZ-1 9590-A or
equivalent meeting Ford specification ESA-M1C198-A.
2. NOTE: The writing on the bearing must face the inboard side of the front wheel spindle, toward the driving tool. Position the bearing in the bore
of the front wheel spindle.
3. Drive the bearing in the front wheel spindle with Spindle Bearing Replacer T8OT-4000-R and Driver Handle T8OT-4000-W until the tool
bottoms out against the front wheel spindle.
4. Install the thrust washer/seal assembly using T92T-4OOO-A.
5. Lightly coat the thrust face of the seal in the bore of the axle shaft and the rolling diaphragm seal lips on the axle shaft with High Temperature 4x4
Front Axle and Wheel Bearing Grease F8TZ-19590-A or equivalent meeting Ford specification ESA-M1C198-A.