F 450 4WD Super Duty V10-6.8L VIN S (1999)
NOTE: Prior to the third removal, clean the bolt threads and apply Loctite(R) 242 or equivalent.
Connect the rear driveshaft assembly to the front driveshaft.
6. WARNING: Replace with new bolts and retainers after the third removal.
NOTE: Prior to the third removal, clean the bolt threads and apply Loctite(R) 242 or equivalent.
Connect the rear driveshaft assembly to the rear axle.
7. Tighten the driveshaft center support bearing bolts.
Two-Piece
Removal
1. Raise and support the vehicle.
2. Index mark the driveshaft at the axle flange.