F 450 4WD Super Duty V10-6.8L VIN S (1999)
7. Remove the driveshaft assembly.
^
For vehicles equipped with an automatic transmission, lower the driveshaft and slide the driveshaft rearward off of the transmission output
shaft.
^
Plug the extension housing to prevent fluid loss.
8. Clean grease deposits, dirt and rust from the following:
^
The driveshaft yoke areas.
^
All driveshaft components.
^
Wipe the bearing and rubber insulator of the driveshaft center bearing. Do not immerse in solvent.
9. Inspect the following:
^
The driveshaft slip yoke boot for rips or holes. Replace if necessary.
^
The driveshaft center bearing support for wear or rough action. If roughness or wear is evident, replace the driveshaft center bearing support.
^
The center bearing rubber insulator for evidence of hardening, cracking or deterioration. Replace if necessary.
Installation