F 450 4WD Super Duty V8-6.4L DSL Turbo (2008)
Removal and Installation
1. Remove the upper fan shroud.
2. Remove the pushpins and the top air deflector.
3. Detach the battery cable from the radiator. Position the battery cable aside.
4. Remove the spring clip and disconnect the lower radiator hose from the radiator.
5. Detach the hood latch release cable retainer from the radiator.
6. Disconnect the transmission fluid cooler hoses and drain the fluid into a suitable container.
7. Remove the RH air deflector pushpins from the radiator.
8. Remove the bolt and position the fuel cooling system radiator aside.
^
To install, tighten to 12 Nm (9 lb-ft).
9. Remove the LH air deflector pushpins from the radiator.
10. Detach the power steering fluid hose retainer from the radiator.
11. Remove the bolts and position the transmission fluid cooler aside.
^
Secure the transmission fluid cooler as needed.
^
To install, tighten to 11 Nm (8 lb-ft).
12. Detach the A/C fitting from the RH battery tray.
13. Detach the A/C hose retainer from the RH inner fender splash shield.
14. Remove the bolts and detach the A/C condenser from the radiator.
^
Secure the A/C condenser as needed.
^
To install, tighten to 8 Nm (71 lb-inch).
15. Remove the lower fan shroud bolts.
^
To install, tighten to 7 Nm (62 lb-inch).
16. With the help of an assistant, remove the radiator.
17. To install, reverse the removal procedure.
^
Check the transmission fluid level and fill as necessary.