F 550 2WD Super Duty V10-6.8L VIN Z Bi-Fuel (2001)
Wheel Bearing: Adjustments
Front - Motorhome
Wheel Bearing Adjustment - Motorhome
CAUTION: Wheel seals on the front axles must be replaced any time the axle lubricants are changed from factory-installed mineral lube to synthetic
lube or vice versa.
CAUTION: If bearings are adjusted too tightly, they will overheat and wear rapidly. An adjustment that is excessively loose can cause pounding and
contribute to uneven tire wear, steering difficulties and inefficient brakes. Check bearing adjustment at regular inspection intervals. New wheel seals
must be installed when the hub is removed. A damaged or worn seal can permit bearing lubricant to reach the brake linings, resulting in ineffective
brake operation and necessitating premature replacement of linings. To check the wheel bearing adjustment, raise the front of the vehicle. Grasp the
tire at the sides, and alternately push inward and pull outward on the tire. If any looseness is felt, adjust the front wheel bearings as follows.
1. Remove the hub cap and gasket from the hub.
2. Remove the cotter pin.
3. While rotating the wheel, tighten the adjusting nut to specification as illustrated to seat the bearings.
4. Back off the adjusting nut until loose.
