ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Air Conditioning (A-C) System Recovery, Evacuation and Charging > < Vacuum Leak Detection
Climate Control System - General Information - Fluorescent Dye Leak Detection Fiesta 1996 (08/1995-02/2002)
General Procedures

Special Tool(s)

120 Watt UV Spot Lamp or equivalent

164-R0721

R-134a Manifold Gauge Set or equivalent

023-R0046 (176-R032A)

NOTE:
NOTE:Since 07/99 vehicles have a fluorescent tracer dye tablet inserted into the A/C system. If tracer dye is present, there is a green cross on the suction accumulator.
NOTE:
NOTE:If it is necessary to add tracer dye, use the dye injector. A/C systems require 7.4 ml (0.25 oz) of Fluoro-Light/P Fluorescent Tracer Dye.
For additional information, refer to Specification in this section.
NOTE:
NOTE:Some vehicles may have signs of refrigerant oil at the spring lock couplers. This may be caused from the assembly process which applies to the fittings before installation to aid in assembly. When a spring lock coupler is suspected of leaking, always wipe the fitting clean and verify the leak with R-134a Automatic Calibration Halogen Leak Detector.
NOTE:
NOTE:The exact location of leaks can be pinpointed by the bright yellow-green glow of the tracer dye. Since more than one leak may exist, always inspect each component.
  1. Check for leaks using a 120 Watt UV Spot Lamp. Always scan all components, fittings and lines of the A/C system.
  1. After the leak is found and repaired, remove any traces of dye with a general purpose oil solvent.
  1. Verify the repair by operating the system for some minutes and inspecting with the UV lamp again.

Air Conditioning (A-C) System Recovery, Evacuation and Charging > < Vacuum Leak Detection