ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Battery and Cables > < Battery to Starter Motor Solenoid Cable - 1.6L

Fiesta 1996 (08.1995-02.2002)

Battery, Mounting and Cables - Battery to Starter Motor Solenoid Cable—1.8L Endura-DI (Lynx) Diesel Fiesta 1996 (08/1995-02/2002)
Removal and Installation

Removal

  1. Disconnect the battery ground cable.

  1. Open the battery positive terminal cover.

  1. Disconnect the battery auxiliary positive cable.

  1. Disconnect the battery positive cable.

  1. Release the battery to starter motor solenoid cable.
    • Cut the tie strap.

  1. Disconnect the generator electrical connector.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Remove the battery to starter motor solenoid cable.
    • Disconnect the starter motor electrical connector.

Installation
  1. NOTE:
    NOTE:When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. It may need to be driven 16 km (10 miles) or more to relearn its adaptive strategy.
    To install, reverse the removal procedure.

Battery and Cables > < Battery to Starter Motor Solenoid Cable - 1.6L