ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Camshaft > < Diagnosis and Testing|Engine

Fiesta 2002.25 (11.2001-)

Engine - 1.4L Duratorq-TDCi (DV) Diesel - Crankshaft Front Seal Fiesta 2002.25 (11/2001-)
In-vehicle Repair

Special Tool(s)

Remover, Crankshaft Oil Seal

303-293 (21-143)

Installer, Crankshaft Oil Seal

303-733 (21-261)
General Equipment
Trolley Jack
Wooden Blocks

Removal

  1. Remove the timing belt.
    For additional information, refer to Timing Belt in this section.

  1. Install the engine front mount support bracket.
    • Install the retaining bolts finger tight.

  1. Install the engine front mount.
    • Install the retaining bolts finger tight.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Remove the crankshaft pulley Woodruff key.

  1. Using the special tool, remove the crankshaft front oil seal.
    • Discard the oil seal.

Installation
  1. NOTE:
    NOTE:A new crankshaft front oil seal is supplied with an alignment and protection sleeve that must be removed following installation.
    Using the special tool and the old crankshaft pulley bolt, install the crankshaft front oil seal.

  1. Install the crankshaft pulley Woodruff key.
  1. Lower the vehicle.

  1. CAUTION:
    CAUTION:Do not support the engine directly on the oil pan.
    Using a trolley jack and suitable wooden blocks, support the engine.

  1. Remove the engine front mount.

  1. Remove the engine front mount support bracket.
  1. Install the timing belt.
    For additional information, refer to Timing Belt in this section.

Camshaft > < Diagnosis and Testing|Engine