| General Procedures All vehicles NOTE:The templates are different for LHD and RHD vehicles. The templates are different for the left and right-hand headlamps. | | -
Print out the corresponding templates at the end of this operation. | | | -
Measure dimension X on the printout of the template. | | | -
Calculate the enlargement/reduction factor Y for the photocopier using the following formula: Y=Z÷X×100. - X = measurement on the printout of the template in mm
- Y = enlargement/reduction factor in %
- Z = original dimension in mm = 100
| | | -
Enlarge/reduce the printout with a photocopier by the calculated percentage. - Compare dimension X on the photocopy with the original dimension.
| | | -
Cut out the prepared templates for the headlamps. | Left-hand drive vehicles | | -
NOTE:Right-hand headlamp only. Align the template on the lens of the headlamp. - Template
- Alignment edges on the headlamp lens
| | | -
NOTE:Left-hand headlamp only. Align the template on the lens of the headlamp. - Template
- Alignment edges on the headlamp lens
| RHD vehicles | | -
NOTE:Right-hand headlamp only. Align the template on the lens of the headlamp. - Template
- Alignment edges on the headlamp lens
| | | -
NOTE:Left-hand headlamp only. Align the template on the lens of the headlamp. - Template
- Alignment edges on the headlamp lens
| All vehicles | | -
CAUTION:Do not damage the headlamp surface. Copy the outline of the template with a suitable pen onto the headlamp lens. | | | -
NOTE:Make sure not to go past the marked area. Mask the marked area with opaque black adhesive tape. | | | -
Repeat steps 10 to 12 for the headlamp on the other side. | | | -
Template for LHD vehicles, right-hand headlamp | | | -
Template for LHD vehicles, left-hand headlamp | | | -
Template for RHD vehicles, right-hand headlamp | | | -
Template for RHD vehicles, left-hand headlamp | | |
