Flex AWD V6-3.5L (2009)
1. Install the clip onto the manual lumbar handle.
2. Align the splines of the manual lumbar handle to the manual lumbar shaft.
3. Push the manual lumbar handle onto the manual lumbar shaft, seating the clip.
9. Install the recliner cover in the following sequence.
1. Return the barrel nut back to the seat before attaching to the seat.
2. Slide the recliner cover post into the barrel nut on the seat.
3. Install the screw at the rear of the recliner cover.
4. Install the scrivet at the rear of the recliner cover.
10. Install the driver seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
Seat Backrest - Front, With Fold Flat
Seat Backrest - Front, With Fold Flat
Removal
WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction
may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to
follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
1. Remove the front passenger seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
2. Remove the inboard recliner lower cover.
1. Remove the screw at the back of the inboard recliner lower cover.
2. Remove the screw at the side of the inboard recliner lower cover.
3. Pull out at the rear of the inboard recliner lower cover to release the retainers and remove.
3. If equipped, remove the manual lumbar handle.
1. Push the cushion trim cover and foam pad back and locate the manual lumbar handle clip under the cushion side shield.
2. Remove the clip and slide the manual lumbar handle off the shaft.
