Flex AWD V6-3.5L (2009)
23. Attach the fold-flat cable retainer and cover to the inboard recliner.
24. Close the backrest trim cover in the following sequence.
1. Close the zippers.
2. Attach the backrest trim cover clips.
3. Attach the backrest trim cover lower J-clips.
25. Attach the cushion side shield in the following sequence. Return all retaining clips back to the cushion side shield before attaching to the seat.
1. Align the 4 cushion side shield clips to the seat and push in seating the clips.
2. Install the screw at the front of the cushion side shield.
3. Install the screw at the rear of the cushion side shield.
4. Install the scrivet at the rear of the cushion side shield.
26. If equipped, install the manual lumbar handle in the following sequence.
1. Install the clip onto the manual lumbar handle.
2. Align the splines of the manual lumbar handle to the manual lumbar shaft.
3. Push the manual lumbar handle onto the manual lumbar shaft, seating the clip.
27. Install the passenger seat.
28. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures.
