Flex FWD V6-3.5L (2010)
13. Release the inboard cushion trim cover J-clip attached to the inboard recliner.
14. Remove the 4 recliner-to-seat track bolts and remove the backrest assembly.
Installation
1. Position the backrest assembly to the seat track and start the 4 recliner-to-seat track bolts by hand.
2. Tighten the 4 recliner-to-seat track bolts.
1. Tighten the rear outboard bolt to 63 Nm (46 lb-ft).
2. Tighten the rear inboard bolt to 63 Nm (46 lb-ft).
3. Tighten the front inboard bolt to 63 Nm (46 lb-ft).
4. Tighten the front outboard bolt to 63 Nm (46 lb-ft).
3. Connect the backrest electrical feed electrical connector. Route and attach the electrical connector and wire harness pin-type retainers to the seat.
4. If equipped, route and engage the DVD wire harness and electrical connector retainers.
5. Connect the side air bag module electrical connector and slide the locking clip back. Route and attach the electrical connector and wire harness
pin-type retainers to the seat.
6. If equipped, install the manual lumbar cable in the following sequence.
1. Position the manual lumbar cable into the adjuster.
2. Position the manual lumbar cable cover into the adjuster.
3. Install the manual lumbar cable retainer.
4. Position the cushion trim cover flap back around the side of the seat, attach all the outboard cushion trim cover J-clips and install the pin-type
retainer.
7. Connect the seat control switch and attach the wire harness pin-type retainer to the cushion frame.
8. Attach the cushion side shield in the following sequence.