Flex FWD V6-3.5L (2010)
3. Position the recliner cable into the 2 retainers under the seat and close the retainers.
4. Attach the cushion cover J-clip at the rear.
5. Install the inboard recliner lower cover in the following sequence.
1. Align the inboard recliner lower cover to the inner cover and push in, seating the rear clips.
2. Install the screw at the side of the inboard recliner lower cover.
3. Install the screw at the back of the inboard recliner lower cover.
6. If equipped, install the manual lumbar cable into the adjuster.
7. Attach the wire harness and cable retainers.
1. Route and attach the side air bag module wire harness pin-type retainer.
-
Seats with power seat track, route the side air bag module wire harness under the seat.
2. If equipped, install the manual lumbar cable cover into the adjuster.
3. If equipped, install the manual lumbar cable retainer.
8. Seats with manual seat track, route the side air bag module wire harness under the seat.
9. Position the cushion cover flap back around the side of the seat, attach all the outboard cushion cover J-clips and install the pin-type retainer.
10. Seats with manual seat track, connect the electrical connector and attach the pin-type retainers under the seat. For correct passenger seat wire
harness routing, refer to Seat Wire Harness Routing See: Service and Repair/Seat Wire Harness Routing.
1. Connect the side air bag module electrical connector and slide the locking clip to the lock position.