Flex FWD V6-3.5L (2010)
-
Unhook the inboard and outboard latch cable ends.
21. Remove the 2 recliner-to-cushion frame bolts and recliner.
-
To install, tighten to 50 Nm (37 lb-ft).
All seats
22. To install, reverse the removal procedure.
23. Check the seat for correct operation.
-
With the seat in the upright position, both latch feet must lock to the strikers.
-
When releasing the seat to the E-Z entry position, the latches must release freely and not bind to the strikers.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
-
Make sure the lower anchor and tether for children wires at the rear of the cushion frame are positioned through the cushion trim cover and
accessible for use after assembly.
Seat - Exploded View, Third Row
Seat - Exploded View, Third Row
Backrest
NOTE: LH shown, RH similar.