Flex FWD V6-3.5L (2010)
4. Engage the side air bag deployment chute retaining clips and snap them together.
-
The side air bag deployment chute must encircle the side air bag module, going completely around the side air bag module and the side of the
backrest frame.
-
Align the side air bag deployment chute to the side air bag module, making sure it is centered around the side air bag module.
5. From the rear of the backrest, attach the backrest trim cover J-clip to the backrest frame wire.
6. Roll the backrest trim cover down and install the 3 second row hog rings.
7. If equipped with a DVD player, install the 2 head restraint guides sleeves. For additional information, refer to Head Restraint Guide Sleeve See:
Head Rest/Service and Repair/Head Restraint Guide Sleeve.
8. Install the 3 first row hog rings.
9. Roll the backrest trim cover all the way down and engage the lower J-clips.
-
If equipped, make sure the manual lumbar cable and side air bag module wire harness are accessible from the outboard side of the backrest
before engaging the lower J-clips.
-
If equipped, make sure the backrest feed wire harness is accessible from the inboard side of the backrest before engaging the lower J-clips.
10. If not equipped with a DVD player, install the 2 head restraint guides sleeves. For additional information, refer to Head Restraint Guide Sleeve
See: Head Rest/Service and Repair/Head Restraint Guide Sleeve.
11. Attach the cushion side shield in the following sequence.
1. Return all retaining clips back to the cushion side shield before attaching to the seat.
2. Align the 4 cushion side shield clips to the seat and push in seating the clips.
3. Install the screw at the front of the cushion side shield.