Flex FWD V6-3.5L (2010)
25. Squeeze the ends of the deployment chute clips together and open the deployment chute.
26. Invert the backrest cover up and remove the second row of hog rings.
27. From the rear of the backrest, separate the backrest cover J-clip attached to the backrest frame wire.
28. Invert the backrest cover up and pull the deployment chute through the backrest foam pad.
29. Remove the backrest cover.
Installation
WARNING: Inspect the seat side air bag module cavity in the seat backrest foam pad for any foreign material. If any foreign material is found,
remove it. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and increases the risk of serious
personal injury or death in a crash.
WARNING: Check the seat side air bag deployment chute for damage. The deployment chute must not be repaired. If there is any damage to
the deployment chute, a new seat back trim cover and deployment chute must be installed as a unit. Failure to follow these instructions may
result in the seat side air bag module deploying incorrectly and increase the risk of serious personal injury or death in a crash.
All seats
1. With the backrest cover inside out, position the backrest cover to the backrest foam pad and frame assembly.
-
Align the head restraint holes in the backrest cover to the holes in the backrest foam pad and frame.
2. Roll the backrest cover down and position the deployment chute through the backrest foam pad opening.
