Flex FWD V6-3.5L (2010)
25. NOTICE: The DVD player wire harness must be routed under the cushion cover and above the cushion cover pin-type retainer or the
Occupant Classification Sensor (OCS) system will not operate correctly.
Attach the cushion cover J-clip and install the cushion cover pin-type retainers.
All seats
26. Install the inboard recliner upper cover in the following sequence.
1. Align the inboard recliner upper cover pocket to the recliner bracket.
2. Pivot the top of the inboard recliner upper cover forward and attach the pocket to the bracket.
3. Push in at the front and seat the clip.
27. Install the inboard recliner lower cover in the following sequence.
1. Align the inboard recliner lower cover to the inner cover and push in, seating the rear clips.
2. Install the screw at the side of the inboard recliner lower cover.
3. Install the screw at the back of the inboard recliner lower cover.
28. Install the outboard recliner upper cover in the following sequence.
1. Position the fold-flat release strap through the opening.
2. Align the outboard recliner upper cover pocket to the recliner bracket.
3. Pivot the top of the outboard recliner upper cover forward and attach the pocket to the bracket.
4. Push in at the front and seat the clip.
29. Install the cushion side shield in the following sequence.
1. Return all retaining clips back to the cushion side shield before attaching to the seat.
2. If equipped, connect the seat control switch.
3. Align the cushion side shield clips to the seat and push in, seating the clips.
4. Install the screw at the back of the cushion side shield.