Flex FWD V6-3.5L (2010)
-
Rotate the cable end guide to release.
-
Disconnect the cable jacket from the cable clamp.
-
Detach the inboard and outboard latch cable jackets from the retainers.
-
Unhook the inboard and outboard latch cable ends.
10. Remove 2 screws, pull and remove the recliner outer cover.
-
Route the backrest release pull strap through the cover opening.
11. WARNING: Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The
recliners are spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this
instruction may result in serious personal injury.
NOTE: Note cable routing for installation.
Remove the 2 cables from the recliner and route them out of the seat cushion frame.
12. Remove the 6 cushion frame-to-seat track nuts and remove the seat track.
-
Detach the electrical connector from the seat track.
-
To install, tighten to 23 Nm (17 lb-ft).
13. To install, reverse the removal procedure.