Flex FWD V6-3.5L (2010)
![background image](/ford/flex_fwd/v6-3.5l/Page-2570002.png)
-
Ignition ON.
-
Do the front parking lamps illuminate?
Yes
REMOVE the jumper wire. GO to P6.
No
REMOVE the jumper wire. REPAIR circuit CLS30 (VT/WH) for an open. TEST the system for normal operation.
-------------------------------------------------
P3 BYPASS THE SJB (REAR LAMPS)
-
Disconnect: SJB C2280d.
-
Connect a fused jumper wire between the positive battery terminal and the SJB C2280d-20, circuit CLS30 (VT/WH), harness side.
-
Do the rear parking lamps illuminate?
Yes
REMOVE the jumper wire. GO to P6.
No
REMOVE the jumper wire. REPAIR circuit CLS30 (VT/WH) for an open. TEST the system for normal operation.
-------------------------------------------------
P4 CHECK FOR VOLTAGE TO THE INOPERATIVE LAMP
-
Disconnect: Inoperative Lamp.
-
Place the headlamp switch in the PARKING LAMPS ON position.
-
Measure the voltage between the inoperative lamp, harness side and ground as follows: