Flex FWD V6-3.5L (2010)
-
Ignition OFF.
-
Disconnect: OCSM C3159.
-
Depower the SRS. Refer to Restraint Systems.
-
Ignition ON.
-
Measure the voltage between the OCSM C3159-1, circuit CBX02 (BN/RD), harness side and ground.
-
Is the voltage greater than 10 volts?
Yes
GO to E2.
No
VERIFY the Smart Junction Box (SJB) fuse 46 (7.5A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the Wiring Diagrams to identify the
possible causes of the circuit short. REPOWER the SRS. REFER to Restraint Systems. CLEAR the DTCs. REPEAT the network test with the scan tool.
See: Diagrams/Electrical Diagrams/Diagrams By Number
-------------------------------------------------
E2 CHECK THE OCSM GROUND CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: Negative Battery Cable.
-
Measure the resistance between the OCSM C3159-14, circuit GD901 (BK), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes
GO to E3.
No
REPAIR the circuit. REPOWER the SRS. REFER to Restraint Systems. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
E3 CHECK THE HS-CAN CIRCUITS BETWEEN THE OCSM AND THE DLC FOR AN OPEN
-
Measure the resistance between the OCSM C3159-18, circuit VDB04 (WH/BU), harness side and the Data Link Connector (DLC) C251-6, circuit
VDB04 (WH/BU), harness side.