Flex FWD V6-3.5L (2010)
4. Remove the 4 nuts, the Y-pipe assembly and discard the exhaust seals.
-
Discard the nuts.
Installation
1. Clean the roll restrictor bolts using a wire brush and apply new threadlock to the threads.
2. Position the roll restrictor in place and install the bolts.
-
Tighten to 90 Nm (66 lb-ft).
3. Install new exhaust seals, position the exhaust Y-pipe assembly in place and install 4 new exhaust Y-pipe assembly nuts.
-
Tighten to 40 Nm (30 lb-ft).
4. Install a new exhaust seal, position the Y-pipe in the exhaust hanger and install 2 new exhaust flange nuts.
-
Tighten to 40 Nm (30 lb-ft).