Focus L4-2.0L (2009)
Removal
WARNING: Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may
result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
WARNING: If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed, install
a new seat side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in the seat side
air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
WARNING: Front seat backrest trim covers installed on seats equipped with seat side air bags cannot be repaired. A new trim cover must be
installed. Cleaning is permissible. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and
increase the risk of serious personal injury or death in a crash.
NOTE: For component identification and locations, refer to Seat - Exploded View, Front See: Service and Repair/Front Seats/Seat - Exploded View,
Front.
1. Remove the seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
2. Release and remove the recliner lever cover.
3. If equipped, remove the cover, screw and seat height adjust handle.
4. Remove the 2 screws, release all the retainer clips and remove the seat cushion side shield.
5. Detach the 2 backrest cover elastic straps at the rear of the cushion frame.
6. NOTICE: Note the position and routing of the wiring harness(es) to aid installation. An incorrectly routed wiring harness may lead to the
wires becoming damaged on the seat mechanism.
Disconnect the seat side air bag module electrical connector, detach the wire harness retainers and route out from the seat cushion.
7. If equipped, disconnect the backrest heater mat electrical connector and route the wire harness from the seat cushion.
8. Release the elastic straps and position aside the cushion cover flaps from the recliner mechanism and backrest pivot.
9. For 2-door passenger seat, detach the seat track release cable from the backrest.
-
Release the backrest latch and move the backrest to the full forward dump position.
-
Detach the cable jacket from the lower clamp on the backrest recliner mechanism.
-
Detach the cable from the upper clamp on the backrest recliner mechanism.
10. WARNING: Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The
recliners are spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this
instruction may result in serious personal injury.
With the backrest fully forward, remove the 4 backrest-to-seat track bolts and backrest.
Installation
1. Position the backrest to the seat track and install the 4 backrest-to-seat track bolts in the following sequence.
1. Install and hand-tighten the 4 bolts.
2. Position the backrest to the first locked recliner position.
3. Tighten the outboard side forward bolt to 47 Nm (35 lb-ft).
4. Tighten the outboard side rearward bolt to 47 Nm (35 lb-ft).
5. Tighten the inboard side rearward bolt to 47 Nm (35 lb-ft).
6. Tighten the inboard side forward bolt to 47 Nm (35 lb-ft).
2. For 2-door passenger seat, connect the seat track release cable to the backrest.