Focus L4-2.0L (2009)
INSTALL the removed fuses. Go To Pinpoint Test C. See: Pinpoint Test C: The Instrument Cluster (IC) Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. GO to N8.
-------------------------------------------------
N8 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISCONNECTED
-
Disconnect: IC C220.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the IC. Go To Pinpoint Test C. See: Pinpoint Test C: The Instrument Cluster (IC) Does Not Respond To The Scan Tool
No
CONNECT the IC. GO to N9.
-------------------------------------------------
N9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RCM DISABLED
NOTE: When re-running the network test, the network test application must be closed first or the screen display reverts back to the prior run network
test results.
-
Disconnect: SJB Fuse 32 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test E. See: Pinpoint Test E: The Restraints Control Module (RCM) Does Not Respond To The Scan
Tool
No
INSTALL the removed fuse. GO to N10.
-------------------------------------------------
N10 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE OCSM DISABLED
NOTE: When re-running the network test, the network test application must be closed first or the screen display reverts back to the prior run network
test results.
-
Disconnect: SJB Fuse 46 (7.5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test D. See: Pinpoint Test D: The Occupant Classification System Module (OCSM) Does Not Respond
To The Scan Tool
No
INSTALL the removed fuse. GO to N11.
-------------------------------------------------
N11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISABLED
NOTE: When re-running the network test, the network test application must be closed first or the screen display reverts back to the prior run network