Focus L4-2.0L (2009)
Fluid - A/T: Service and Repair
Transmission Fluid Drain and Refill
4F27E
Transmission Fluid Drain and Refill
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the transmission fluid cooler outlet tube from the transmission fluid cooler.
1. Remove the secondary latch.
2. Slide the latch out of the transmission fluid cooler tube to the unlocked position.
3. Remove the transmission fluid cooler tube from the transmission fluid cooler and position the transmission fluid cooler tube aside.
3. Attach a length of suitable drain hose to the transmission fluid cooler.
4. Insert the drain hose into a calibrated 10L (10.5 qt) container.
5. NOTICE: To prevent damage to the transaxle, do not run the engine above idle.
NOTE: If the transmission fluid return rate is less than 0.95L (1.0 qt) in 30 seconds, or if the return hose pulsates, check for restrictions at the
pump, transmission fluid cooler or transmission fluid cooler tubes.
Run the engine at idle and pump out 3L (3.17 qt) of transmission fluid.
6. Switch the engine OFF.
7. Remove the transmission fluid level indicator from the transmission fluid level indicator tube.
