Focus L4-2.0L (2009)
8. Add 3L (3.17 qt) of transmission fluid to the transaxle.
9. NOTICE: To prevent damage to the transaxle, do not run the engine above idle.
NOTE: If the transmission fluid return rate is less than 0.95L (1.0 qt) in 30 seconds, or if the return hose pulsates, check for restrictions at the
pump, transmission fluid cooler or transmission fluid cooler tubes.
Run the engine at idle and pump out 3L (3.17 qt) of transmission fluid.
10. Switch the engine OFF.
11. Add 3L (3.17 qt) of transmission fluid to the transaxle.
12. NOTICE: To prevent damage to the transaxle, do not run the engine above idle.
Run the engine at idle and pump out 3L (3.17 qt) of transmission fluid.
13. Switch the engine OFF.
14. Remove the length of drain hose from the transmission fluid cooler.
15. Connect the transmission fluid cooler outlet tube to the transmission fluid cooler.
1. Install the transmission fluid cooler outlet tube on the transmission fluid cooler.
2. Slide the latch into the transmission fluid cooler tube to the locked position.
3. Install the secondary latch.