Removal and Installation Special Tool(s) | Separator, Ball Joint 211 - 020 (13 - 006) | Removal | -
Loosen the front wheel nuts. | | -
Loosen the tie - rod end locknut and remove the retaining nut. - Loosen the locknut.
- Remove the retaining nut.
| | -
Using the special tool, release the tie - rod end from the wheel knuckle. | | -
NOTE:Make a note of the number of turns used to remove the tie - rod end. Remove the tie - rod end and locknut. | Installation | -
NOTE:Make sure the tie - rod end is secured by the same number of turns used to remove it. Install a new tie - rod end retaining nut. After installation, check the toe adjustment. For additional information, refer to Section 204-00 Suspension System - General Information. To install, reverse the removal procedure. | | |