Removal and Installation Removal | -
Disconnect the fuel vaporizer to fuel filter supply line from the fuel filter. - Discard the retaining clip.
| | -
Disconnect the alternative fuel control module electrical connectors. | | -
Disconnect the fuel vaporizer fuel supply line union from the fuel vaporizer. | | -
Disconnect the heater hoses from the fuel vaporizer. - Using a suitable Brake hose clamp(s), clamp off the heater hoses.
- Disconnect the heater hoses from the fuel vaporizer.
- Allow the coolant to drain into a suitable container.
| | -
Disconnect the fuel vaporizer vacuum lines from the fuel vaporizer and manifold absolute pressure (MAP) sensor. | | -
Detach the brake fluid reservoir. | | -
Disconnect the fuel vaporizer electrical connector. | | -
Remove the fuel vaporizer bracket retaining bolt. | | -
Remove the fuel vaporizer bracket retaining nut. | | -
Remove the fuel vaporizer bracket retaining bolt and remove the fuel vaporizer. | | -
Disconnect the fuel vaporizer and MAP sensor electrical connectors. | | -
Remove the fuel vaporizer retaining bracket. | | -
Disconnect the fuel supply line from the vaporizer. - Discard the O-ring seal.
| Installation | -
NOTE:Install a new retaining clip. NOTE:Install a new O-ring seal. To install, reverse the removal procedure. | | -
WARNING:Before the vehicle is tested for normal operation, carry out the fuel system leak test. Failure to follow this instruction may result in personal injury. | | -
CAUTION:If a new fuel vaporizer has been installed the fuel system differential pressure setting will have to be checked and adjusted to specification. Before the vehicle is tested for normal operation, carry out the fuel system differential pressure check. | | |