Removal and Installation Special Tool(s) | Wrench, Sender Unit, Fuel Tank 310-069 (23-055) | Removal | -
Remove the fuel tank. For additional information, refer to Tank-Fuel in this section. | | -
Disconnect the fuel supply and return lines from the module. | | -
Using the special tool, remove the locking ring. | | -
CAUTION:Make sure the float or arm are not damaged while removing the fuel pump module. Remove the fuel pump module. - Rotate the module counterclockwise.
- Lift the module from the fuel tank.
| | -
Remove and discard the locking ring seal. | Installation | -
NOTE:Make sure the arrows on the fuel tank and fuel pump module are aligned correctly. NOTE:Install a new locking ring seal and make sure it is seated correctly on the fuel tank. To install, reverse the removal procedure. | | |