ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
310-03 Speed Control > < Accelerator Cable - 1.6L Zetec-SE (Sigma)-1.4L

Focus 1999 (08.1998-12.2004)

Acceleration Control - Accelerator Cable—1.6L Zetec-E (Zetec)/1.8L Zetec-E (Zetec)/2.0L Zetec-E (Zetec) Focus 1999 (08/1998-12/2004)
Removal and Installation

Removal
  1. Disconnect the accelerator cable.
    1. Remove the accelerator retaining clip.
    1. Disconnect the accelerator cable.

  1. Detach the accelerator cable from the bracket.
    1. Rotate the cable to release.
    1. Detach the accelerator cable.

  1. Remove the footwell trim panel.

  1. Disconnect the accelerator cable from the pedal.

  1. Attach a draw cord to the accelerator cable to assist with installation.
  1. Remove the accelerator cable.

Installation

  1. NOTE:
    NOTE:The rubber grommets must be installed into the bulkhead and throttle body bracket before the accelerator cable is installed into the grommets.
    To install, reverse the removal procedure.

310-03 Speed Control > < Accelerator Cable - 1.6L Zetec-SE (Sigma)-1.4L