Removal and Installation Removal NOTE:The pollen filter is located on the passenger side below the cowl panel. NOTE:Position the wipers in the vertical position. NOTE:The sealing strip will be damaged when the cowl panel grille is removed. Vehicles built up to 01/1999: | -
Remove the cowl panel grille on the passenger side. - Remove the caps.
- Remove the bolts.
- Clean the sealing strip residues from the cowl panel grille and the windshield.
| Vehicles built up to 05/1999 | -
Remove the cowl panel grille on the passenger side. - Remove the caps.
- Remove the bolts.
- Release the clips.
- Clean the sealing strip residues from the cowl panel grille and the windshield.
| Vehicles built from 05/1999 | -
Unclip the cowl panel grille on the passenger side. - Clean the sealing strip residues from the cowl panel grille and the windshield.
| | -
Remove the white sliding clips from the body panel mounting points and insert them into the mounting points on the back of the cowl panel grille. | All vehicles | -
Remove the pollen filter retaining flap. | | -
Remove the pollen filter. | Installation All vehicles | -
NOTE:A protective screen with a rubber edge is inserted between the wiper motor and the filter housing. This must be cleaned of dirt every time the filter is changed. NOTE:Note the flow direction for the pollen filter. Install the pollen filter. | | -
Clip in the pollen filter retaining flap. | Vehicles built up to 05/1999 | -
Shorten the foam block to 55 mm (RHD vehicle shown). | | -
Drill an additional water drain hole in the cowl panel grille (RHD vehicle shown). | All vehicles | -
Apply the cowl panel grille double sided adhesive strip. - Remove the protective film and apply the cowl panel grille adhesive strip to the cowl panel grille, starting from the middle.
- Bend back about 40 mm of the second protective film at the outer end by 90°.
| | -
Pull off the second protective film from the cowl panel grille adhesive strip and press the cowl panel grille fully into place in the region of the windshield using a suitable roller. | Vehicles built up to 01/1999: | -
Install the passenger side cowl panel grille. - Install the bolts.
- Install the caps.
| Vehicles built up to 05/1999 | -
CAUTION:Make sure that all clips are fully engaged. Install the passenger side cowl panel grille. - Install the bolts.
- Install the caps.
- Attach the clips.
| Vehicles built from 05/1999 | -
CAUTION:Make sure that all clips are fully engaged. Clip the passenger side cowl panel grille into place. | |