Removal and Installation Special Tool(s) | Remover/Installer, Cooling Hose Clamp 303-397 (24-003) | Removal | -
Using the special tool, disconnect the coolant hoses from the heater core. | | -
Remove the rear footwell vent air ducts. | | -
Remove the footwell lower trim panel. | | -
Open the glove compartment. | | -
Remove the footwell vent air duct. | | -
Close the glove compartment. | | -
Remove the footwell trim. - Remove the left-hand and right-hand retaining screws (right-hand side shown).
| | -
Remove the accelerator pedal. - Disconnect the electrical connector.
| | -
NOTE:Take care not to damage the seat when detaching the clip. Detach the rear steel clip. | | -
Remove the left-hand and right-hand in-vehicle crossbeam bracket (right-hand side shown). | | -
Remove the heater core air duct housing. | | -
Remove the heater core housing. | | -
Remove the heater core retaining bolt. | Installation | -
To install, reverse the removal procedure. | | |