ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Rear Door Window Regulator and Motor > < Rear Door Window Regulator
Glass, Frames and Mechanisms - Front Door Window Regulator and Motor Focus 1999 (08/1998-12/2004)
Removal and Installation

Removal

  1. Remove the front door trim panel. For additional information, refer to Section  501-05 Interior Trim and Ornamentation.

  1. Remove the side impact bolster.

  1. Detach the speaker from the front door panel.

  1. Remove the speaker.
    • Disconnect the electrical connector.

  1. Detach the door latch release handle from the front door panel.

  1. CAUTION:
    CAUTION:Do not touch the adhesive surface as re-bonding will be impaired.
    Detach the watershield from the front door panel.

  1. Detach the window one-touch down relay from the front door panel.

  1. Connect the power window control switch electrical connector.

  1. Remove the front door window glass clamp bolts.
    • Align the retaining bolts with the access holes.

  1. Detach the front door window glass from the regulator.
    1. Hold the front door window glass at the top of the opening.
    1. Lower the regulator.

  1. CAUTION:
    CAUTION:Make sure the front door window glass is adequately supported.
    Using suitable hooks, secure the front door window glass.

  1. Disconnect the power window control switch electrical connector.

  1. Disconnect the front door window regulator motor electrical connector.
    • Detach the wiring harness from the clip.

  1. Remove the front door window regulator and motor.
    • Remove the screws.

Installation

  1. To install, reverse the removal procedure.

Rear Door Window Regulator and Motor > < Rear Door Window Regulator