| Removal and Installation Electric hand drill Drill bit 8 mm Removal All Vehicles | | -
Remove the rear door trim panel.
For additional information, refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
| | | -
Remove the side impact bolster. | | | -
Detach the door speaker (if equipped). | | | -
Disconnect the speaker electrical connector and remove the door speaker (if equipped). | | | -
Detach the door latch release handle. | | | -
CAUTION:Do not touch the adhesive surface as re-bonding will be impaired. Detach the watershield. - Using a suitable plastic knife (disposable cutlery), cut through the Butyl strip to enable the watershield to be peeled back.
| | | -
Remove the door glass top run retainer. | Vehicles with manual windows | | -
Install the window regulator handle. | Vehicles with power windows | | -
Connect the door glass operating switch electrical connector. | All Vehicles | | -
Align the regulator clamp with the access hole (power window shown). | | | -
NOTE:Position the regulator operating cable to one side when drilling the retaining pin, in order to prevent damage. Detach the door glass from the regulator clamp. - Using a suitable electric hand drill and a drill bit 8 mm, remove the retaining pin.
- Push out the retaining sleeve.
- Remove the door glass from the regulator clamp.
- Discard the retaining sleeve.
| | | -
Support the glass, lower the glass and regulator to the lowest position. | | | -
Position the lower part of the door glass top run outside the door. | | | -
NOTE:To aid removal of the door glass, stand on the inner side of the door. Make sure the glass is removed from the inside of the door. Remove the window glass. | Installation All vehicles | | -
CAUTION:Make sure vise jaw protectors are used. NOTE:Make sure that the retaining sleeve is central in the door glass. Attach a new retaining sleeve and retaining pin to the door glass. - Position the retaining sleeve in the door glass.
- Using a suitable vise, press the retaining pin into the retaining sleeve.
| | | -
Install the window glass in the door. | | | -
Attach the door glass to the regulator clamp. - Push the door glass firmly down to engage the retaining pin and retaining sleeve into the regulator clamp.
| | | -
Position the lower part of the door glass top run on the inside of the door. | | | -
Install the door glass top run retainer. | | | -
Attach the door latch release handle. | | | -
Connect the door speaker electrical connector (if equipped). | | | -
Install the door speaker (if equipped). | | | -
Install the side impact bolster. | Vehicles with manual windows | | -
Remove the window regulator handle. | Vehicles with power windows | | -
Disconnect the door glass operating switch electrical connector. | All vehicles | | -
Install the door trim panel.
For additional information, refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
| |
