Removal and Installation Removal All Vehicles | -
WARNING:Always wear safety glasses when working on an air bag equipped vehicle and when handling an air bag module. Failure to follow this instruction may result in personal injury. | | -
Detach the instrument panel lower panel. - Remove the screws.
- Detach the clip.
| | -
Remove the instrument panel lower panel. - Detach the data link electrical connector.
| | -
Remove the steering column upper shroud. - Detach the clips using a thin bladed screwdriver (one each side).
| | -
Detach the audio unit control switch (if equipped). - Detach the clip using a thin bladed screwdriver.
- Disconnect the electrical connector.
| | -
Remove the steering column lower shroud. - Release the steering column locking lever.
- Remove the screws.
| | -
Detach and lower the steering column. - Remove and discard the nyloc nuts.
| | -
Remove the audio unit. For additional information, refer to Section 415-01 Audio Unit. | | -
Remove the glove compartment. | | -
Detach the climate control and audio unit trim panel. - Remove the screws.
- Detach the clips.
| | -
Remove the climate control and audio unit trim panel. - Disconnect the electrical connectors.
- Disconnect the climate control cables.
| | -
Remove the heater core housing assembly panel. - Remove the screws (left-hand side shown, right-hand similar).
| Vehicles with cellular phone | -
Detach the cellular phone handset holder. | All vehicles | -
Detach the front of the center console. - Remove the screws (one each side).
| | -
Remove the ashtray from the rear of the center console. | | -
Detach the rear of the center console. | | -
Move the center console rearwards. | | -
Remove the instrument panel upper retaining clips. - Install the M6 x 100 mm bolt.
- Using a suitable tool, remove the retaining clips.
| | -
Remove the instrument panel side trim panels. | | -
Remove the instrument panel side bolts (left-hand side shown, right-hand side similar). | | -
Detach the instrument panel. - Detach the defroster tubes.
| | -
Remove the instrument panel. | Installation | -
To install, reverse the removal procedure. | |