ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Rear Bumper Cover - 3-Door-5-Door > < 501-19 Bumpers|Specifications
Bumpers - Front Bumper Cover Focus 1999 (08/1998-12/2004)
Removal and Installation

Removal

All vehicles

  1. Remove the radiator air deflector.

  1. Remove the radiator grille.

  1. Remove the headlamp washer on both sides (if equipped).
    1. Pull the headlamp washer forwards to access the clip.
    1. Using a suitable screwdriver release the clip.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Detach the fender splash shield from the bumper cover on both sides.

  1. Detach the bumper cover from the fender on both sides.
Vehicles built up to 10/2001

  1. Disconnect the turn signal lamp electrical connector on both sides.
All vehicles

  1. Disconnect the fog lamp electrical connector on both sides (if equipped).
  1. Lower the vehicle.

  1. CAUTION:
    CAUTION:Protect the bumper cover using a soft cloth to prevent damage.
    Release the bumper cover retaining clips.

  1. Remove the bumper cover.
    1. Lower the bumper cover.
    1. Detach the bumper cover from the radiator splash shield.

Installation

  1. To install, reverse the removal procedure.

Rear Bumper Cover - 3-Door-5-Door > < 501-19 Bumpers|Specifications