Removal and Installation Special Tool(s) | Remover/Installer, Cooling Hose Clamp 303-397 | General Equipment Removal All vehicles NOTE: The following step is only necessary if the power steering pump pressure line to the steering gear is to be removed and refitted but not replaced. | -
For additional information, refer to: Power Steering Pump - 1.4L Duratec-16V (Sigma)/1.6L Duratec-16V (Sigma) (211-02 Power Steering, Removal and Installation). | All vehicles NOTE: The following steps are only necessary if the power steering pump pressure line to the steering gear is to be replaced. | -
For additional information, refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation). | | -
WARNING:Make sure that any escaping fluid is collected. CAUTION:Make sure that all openings are sealed. | Vehicles with power steering oil cooler. | -
WARNING:Make sure that any escaping fluid is collected. CAUTION:Make sure that all openings are sealed. | Vehicles without power steering oil cooler | -
WARNING:Make sure that any escaping fluid is collected. CAUTION:Make sure that all openings are sealed. | All vehicles | -
For additional information, refer to: Lifting (100-02 Jacking and Lifting, Description and Operation). | Left-hand drive vehicles | -
WARNING:Make sure that any escaping fluid is collected. CAUTION:Make sure that all openings are sealed. | Right-hand drive vehicles | -
WARNING:Make sure that any escaping fluid is collected. CAUTION:Make sure that all openings are sealed. | Installation Left-hand drive vehicles Right-hand drive vehicles All vehicles Vehicles with power steering oil cooler. Vehicles without power steering oil cooler All vehicles | -
For additional information, refer to: (211-00 Steering System - General Information) Power Steering System Filling - 1.6L Duratec-16V (Sigma) (General Procedures), Power Steering System Bleeding - 1.6L Duratec-16V (Sigma) (General Procedures). | |