Ford Workshop Service and Repair Manuals

Installer, Crankshaft Seal

303-395 (21-171)

1. Remove the timing belt.
   For additional information, refer to: Timing Belt - Vehicles Built Up To: 04/2005 (303-01B Engine - 1.6L Duratec-16V Ti-VCT (Sigma), In-vehicle Repair).
   

2. Remove the crankshaft timing pulley.

3. Detach the air conditioning (A/C) compressor from the cylinder block and position it to one side.

4. Using the special tool, remove the crankshaft front seal.
   • Discard the seal.

5. Remove the oil pan.
   For additional information, refer to: Oil Pan (303-01B Engine - 1.6L Duratec-16V Ti-VCT (Sigma), In-vehicle Repair).
   

6. Remove the oil pump (engine shown removed for clarity).
   • Detach the oil pick up tube from the oil pump.
   • Discard the gaskets.

1. 

   NOTE:Install a new oil pump gasket.
   

   NOTE:Install a new oil pick up tube gasket.
   Install the oil pump (engine shown removed for clarity).
   • Attach the oil pick up tube to the oil pump.

2. Using the special tool, install the crankshaft front seal.

3. Install the oil pan.
   For additional information, refer to: Oil Pan (303-01B Engine - 1.6L Duratec-16V Ti-VCT (Sigma), In-vehicle Repair).
   

4. Attach the air conditioning (A/C) compressor to the cylinder block.

5. Install the crankshaft timing pulley.

6. Install the timing belt.
   For additional information, refer to: Timing Belt - Vehicles Built Up To: 04/2005 (303-01B Engine - 1.6L Duratec-16V Ti-VCT (Sigma), In-vehicle Repair).