ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Valve Stem Seals > < Crankshaft Front Seal

Focus 2004.75 (07.2004-)

Engine - 2.5L Duratec-ST (VI5) - Intake Manifold Focus 2004.75 (07/2004-)
Removal and Installation

Removal

NOTE:
NOTE:Removal steps in this procedure may contain installation details.
  1. Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions (100-00 General Information, Description and Operation).
  1. Release the fuel system pressure.
    Refer to: Fuel System Pressure Release - 1.4L Duratec-16V (Sigma)/1.6L Duratec-16V Ti-VCT (Sigma)/1.8L Duratec-HE (MI4)/2.0L Duratec-HE (MI4) (310-00 Fuel System - General Information, General Procedures).
  1. Disconnect the battery ground cable.
    Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
  1. Remove the air cleaner.
    Refer to: Air Cleaner - Vehicles With: PCM Security Shield (303-12B Intake Air Distribution and Filtering - 2.5L Duratec-ST (VI5), Removal and Installation).
    Refer to: Air Cleaner - Vehicles Without: PCM Security Shield (303-12B Intake Air Distribution and Filtering - 2.5L Duratec-ST (VI5), Removal and Installation).

  1. Torque: 10 Nm

  1. Torque: 10 Nm

  1. Torque: 10 Nm

  1. Torque: 24 Nm

Installation

  1. To install, reverse the removal procedure.
  1. Initialize the door window motors.
    Refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).

Valve Stem Seals > < Crankshaft Front Seal