ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Selector Lever Cable > < Selector Lever Assembly

Focus 2004.75 (07.2004-)

Automatic Transmission/Transaxle External Controls - Vehicles With: 6DCT450/CFT23 - Selector Lever Assembly Focus 2004.75 (07/2004-)
Disassembly and Assembly

Disassembly
  1. Remove the selector lever knob.
    • Remove the bolt.

  1. Pull out the plunger and spring of the selector lever lock.

  1. Unclip the selector lever unit bezel from the selector lever unit (six clips).

  1. Remove the selector lever unit bezel.
    1. Disconnect the connector for the selector lever lock solenoid.
    1. Detach the ignition key interlock switch from the gear selector housing.
    1. Detach the selector lever central connector from the gear selector housing.
    • Unhook the selector lever unit cable from the cable guide.

  1. Remove the cover for the manual selector lever lock.
    • Press down the retaining clip of the manual selector lever lock cover until the cover of the manual selector lever lock can be pulled out.

  1. NOTE:
    NOTE:Solenoid - gear selector cover plate faces upwards.
    Remove the selector lever cover.

Assembly

  1. CAUTION:
    CAUTION:Check that the cable of the selector lever unit is in the correct installation position.
    NOTE:
    NOTE:Apply thread locking compound to the selector lever knob bolt.
    To assemble, reverse the disassembly procedure.

Selector Lever Cable > < Selector Lever Assembly