In-vehicle Repair Special Tool(s) | Remover, Crankshaft Rear Oil Seal 303-336 (21-151) | | Installer, Output Drive Flange Oil Seal 308-112 (16-043A) | General Equipment Self-tapping screw 2.5 x 15 mm Removal | -
Remove the transmission. For additional information, refer to: Transaxle - 2.0L Duratorq-TDCi (DW) Diesel (308-03C Manual Transmission/Transaxle - Vehicles With: 6-Speed Manual Transmission (MMT6), Removal). | | -
Remove the clutch slave cylinder. For additional information, refer to: Clutch Slave Cylinder (308-02C Clutch Controls - Vehicles With: 6-Speed Manual Transmission (MMT6), Removal and Installation). | | -
CAUTION: Do not damage the input shaft roller bearing. NOTE: Carry out operation step only at the position shown. Using the special tool make a hole in the input shaft oil seal. - Input shaft
- Input shaft oil seal
- Input shaft roller bearing
| | -
CAUTION: Do not damage the input shaft roller bearing. NOTE: Carry out operation step only at the position shown. Remove and discard the input shaft oil seal. - Pull out the input shaft oil seal with pliers.
| Installation | -
CAUTION: Apply adhesive tape over the splines of the input shaft to prevent the input shaft oil seal being damaged. NOTE: Install a new input shaft oil seal. Install the input shaft oil seal with the special tool. | | -
Remove the adhesive tape from the input shaft splines. | | -
Install the clutch slave cylinder assembly. For additional information, refer to: Clutch Slave Cylinder (308-02C Clutch Controls - Vehicles With: 6-Speed Manual Transmission (MMT6), Removal and Installation). | | -
Install the transmission. For additional information, refer to: Transaxle - 2.0L Duratorq-TDCi (DW) Diesel (308-03C Manual Transmission/Transaxle - Vehicles With: 6-Speed Manual Transmission (MMT6), Installation). | | -
Bleed the clutch system. For additional information, refer to: Clutch System Bleeding (308-00 Manual Transmission/Transaxle and Clutch - General Information, General Procedures). | | |