ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Accelerator Cable > < Acceleration Control

Focus 2004.75 (07.2004-)

Acceleration Control - Accelerator Pedal Focus 2004.75 (07/2004-)
Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.

2. Remove the components in the order indicated in the following illustration(s) and table(s).

 
Item
Part Number
Description
1
-
Instrument panel lower trim panel
2
-
Instrument panel insulation pad
3
-
Instrument panel lower trim panel retraining clips
See Installation Detail

 
Item
Part Number
Description
4
-
Accelerator pedal retaining nuts
See Installation Detail
5
-
Accelerator pedal
6
-
Accelerator pedal electrical connector
See Removal Detail

3. To install, reverse the removal procedure.

  1. Initialize the door window motors. For additional information, refer to Section  501-11 Glass, Frames and Mechanisms.

Removal Details

Item 6 : Accelerator pedal electrical connector

NOTE:
NOTE:The accelerator pedal electrical connector can only be disconnected 10 times during the lifetime of the accelerator pedal. Failure to follow this instruction may cause damage to the accelerator pedal electrical connector.
  1. Using a suitable marker, mark the accelerator pedal electrical connector when it has been disconnected from the accelerator pedal wiring harness.

Installation Details

Item 4 : Accelerator pedal retaining nuts

  1. Loosely install all the accelerator pedal retaining nuts before tightning.

Item 3 : Instrument panel lower trim panel retraining clips

  1. Install the instrument panel lower trim panel retraining clips to the instrument panel lower trim panel.

Accelerator Cable > < Acceleration Control