Removal and Installation | -
Remove the engine cover (2.0L diesel shown). | 2. Remove the components in the order indicated in the following illustration(s) and table(s). CAUTION:Make sure that the windshield wiper motor is in the park position. NOTE:Vehicles with diesel engines only 1 - Windshield wiper arm nuts 3 - Clips, cowl panel grille 5 - Bulkhead extension screws CAUTION:After removing the low pressure switch, make sure that the low pressure switch valve is completely closed, in order to prevent refrigerant from escaping. Failure to observe this instruction can lead to injury. 7 - Low pressure switch connector 9 - Low pressure switch seal 3. To install, reverse the removal procedure. | -
NOTE:Vehicles with diesel engines only Check the angle of the windshield wiper arms in relation to the windshield. For additional information, refer to: Vorderen Wischerarm einstellen (501-16, General Procedures). | Removal Details Item 6 : Bulkhead extension | -
CAUTION:If brake fluid comes into contact with the paintwork, the affected area must be washed down immediately with cold water. Detach the brake fluid reservoir from the bulkhead extension and tie it back to one side. | Installation Details Item 2 : Windshield wiper arms CAUTION:Move the windshield wiper motor to the parked position before installing the wiper arms. |